Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
Hex bolt M 12 x 1.5 x 110 .................................................................................................................. 110 Nm plus an additional 90° ( 1 1/4 turn)
Shock absorber to control arm
*Self-locking nut, ............................................................................................................................................................................................ 70 Nm
*Replace each time after removing
Aligning
Subframe to vehicle, aligning
Aligning subframe transversally
-
Determine distance between subframe and longitudinal member.
Gap -a- must be same on left and right-hand sides.
Aligning Subframe Longitudinally
Aligning subframe longitudinally
-
Measure dimension -a-.
Dimension -a-: 418 +2 mm
Tighten bolts for subframe
Hex bolt M 12 x 1.5 x 110 ................................................................................................................ 110 Nm plus an additional 90° (1/4 turn)
*Replace each time after removing
-
After installing check position of steering wheel during a test drive.
-
If steering wheel is not in straight ahead position the front axle tracking must be checked!
Bonded Rubber Mountings For Subframe, Replacing
Bonded rubber mountings for subframe, replacing
Special tools and equipment required