Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
-
Thread M10 x 100 screw -3- into rear final drive.
-
To remove screws -1-, hold front and rear of driveshaft steady with a spanner -2-.
-
At each constant-velocity joint on driveshaft, remove upper three bolts.
Vehicles without tapped holes in front of rear final drive
-
Lower vehicle.
-
Insert VAG 1869/2 brake pedal applicator.
-
Operate brake pedal using brake pedal applicator.
-
Raise vehicle.
-
At each constant velocity joint on driveshaft, remove lower three bolts.
-
Lower vehicle.
-
Remove VAG 1869/2 brake pedal applicator.
-
Raise vehicle.
-
Turn two rear wheels in same direction to move driveshaft 1/2 turn (180°).
-
Lower vehicle.
-
Insert VAG 1869/2 brake pedal applicator.
-
Operate brake pedal using brake pedal applicator.
-
Raise vehicle.
All vehicles
Driveshaft with 60 mm diameter housing front and rear
Note: Do not place the installation tool on balance pieces.