Passat Sedan 4Motion V6-3.6L (BLV) (2007)
^
Drill (commercially available)
Drive flange seal, removing
-
Remove sound insulation.
-
Place Drip Tray For VAS 6100 VAS 6208 underneath.
-
Mark position of - nuts - used to secure lower control arm to suspension strut.
Re-establish position when reassembling.
-
Remove lower control arm from suspension strut.
-
Press off drive axle from transmission.
Left
-
Remove drive axle.
Right
-
Place drive axle upward as far as possible and secure in this position.
Protective coating of shaft must not be damaged, use cable ties made of plastic are very suitable.
-
Seal opening of drive axle at transmission using clean rag - A -.
Note:
^
Grease drill - B - so that drill shavings stick.
^
Drill only through metal ring - C -, otherwise transmission may be damaged.
-
Carefully drill hole - B - (2 to 4 mm in diameter) in outer metal ring of oil seal.