Passat Sedan 4Motion W8-4.0L (BDP) (2002)
/Page-1047001.png)
Fuel Gauge Sender: Service and Repair
Sender For Fuel Gauge, Removing And Installing
Special tools, testers and auxiliary items required
-
Wrench for fuel tank sender 3087
-
Torque wrench (40...200 Nm) V.A.G1332
Removing
NOTE:
-
The fuel tank must not be more than 1/3 full.
-
Empty fuel tank using fuel suction unit VAS5190 if necessary.
-
Observe safety measures before performing repair work.
-
Turn ignition and all electrical consumers off and remove ignition key.
-
With ignition switched off disconnect battery ground strap.
-
Remove flange, Fuel delivery unit, removing and installing.
-
Pull off Sender for fuel gauge -G- connector on underside of flange.
-
Unclip sender for fuel gauge at baffle housing in fuel tank and remove.
-
Press locking tab on sender for fuel gauge in - direction of arrow - and pull upward (illustration shows uninstalled sender for fuel gauge ).
