Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Remove anchor - 1 - from window regulator motor - arrow -.
-
Door window can now by pushed down to height of installation holes in assembly carrier.
NOTE: Motor must not be re-used.
Siemens window regulators
-
Remove bolts - 1 - (4 X).
-
Remove housing - 2 - from window regulator motor.
NOTE: Motor must not be re-used.
-
By turning anchor - 1 -, door window can be moved down to height of installation hole.
All vehicles
-
Lower door window until spreader pins - 2 - and spreader plug - 3 - are accessible in window cut-out.
NOTE: When pressing out spreader pin and spreader plug, make sure that outer door plate does not bow.
-
Install a 5 mm bolt (approx. 70 mm long) into spreader pin - 2 - and remove from spreader plug - 3 -.
-
Now install a 8 mm bolt (approx. 80 mm long) into spreader plug - 3 -.
NOTE: When screwing bolt into spreader plug, do not use excessive force on anchor otherwise it may fall backward into door.
-
Remove spreader plug from window regulator guide and thereby from door window.
-
During this, cable - 2 - must be pressed to side from window using a screwdriver.