Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Trunk / Liftgate Shock / Support: Service and Repair
Gas-filled Strut, Removing
-
Open and support tailgate .
-
Reach under spring clips - 2 - using a small screwdriver.
-
Lift spring clips - 2 - only far enough so that spring clips can be slid over ball socket in direction of - arrow -.
-
Remove gas-filled strut - 1 - from ball studs - 3 - and - 4 -.
After removing gas-filled strut - 1 -, immediately slide back spring clips - 3 - again.
CAUTION: Proceed carefully when re-using gas-filled strut. Spring clips must not be pried completely out of ball socket, otherwise
spring clips will be damaged. Gas-filled strut springs out of mount and leads to damage and injury to operator.
-
Tightening torques: Ball stud - 3 - and - 4 - 21 Nm.
-
Releasing gas from gas-filled strut.