Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Note:
^
Follow the brake lathe manufacturer's instructions for set-up and machining.
^
Wash the brake disc with a soap and water solution upon completion of resurfacing to remove all machining particles.
^
Re-measure brake disc thickness in 4 locations using either the Pro Cut disc thickness measuring tool Part No.50-902 or the Hunter disc thickness
measuring tool Part No.25-99-2, to verify that minimum thickness is still exceeded. If recorded brake disc measurement is less than the minimum
thickness, the brake disc MUST be replaced.
Note:
^
Measure brake disc lateral run out using Pro Cut Disc Lateral run out measuring kit Part No. 50-700FC or the Hunter Disc Lateral run out
measuring kit Part No.25-128-2 with a dial indicator.
Run out must not exceed 0.1 mm.