Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Remove oil pressure switch (F1) and screw into tester.
-
Screw tester into oil pan in place of oil pressure switch.
-
Connect brown wire of tester to Ground (-).
-
Connect diode test lamp VAG 1527 using auxiliary cables from VAG 1594 to battery positive (+) and oil pressure switch.
-
Start engine and increase speed slowly. At 1.2-1.6 bar LED must light up, otherwise replace oil pressure switch.
-
Increase engine speed further. At 2000 rpm and at an oil temperature of 80° C oil pressure should be at least 2.0 bar.