Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Control Module HVAC: Service and Repair
A/C Control Head -E87- W/Climatronic Control Module -J255-
A/C Control Head -E87- With Climatronic Control Module -J255-, Removing And Installing
CAUTION!
-
Before working on the electrical system, obtain radio security code and disconnect battery Ground (GND) strap.
-
When reconnecting battery, always check operation of vehicle equipment such as radio, clock, and power windows.
NOTE: Climatronic control module -J255- and A/C control head -E87- are integrated into a single unit and cannot be serviced separately.
Removing
-
Using a screwdriver with a protected tip, carefully unclip control head trim at locations indicated by -arrows-.
-
Remove instrument panel screws -arrows-.
-
Pull A/C control head/control unit from instrument panel opening.
-
Disconnect electrical connections on rear of unit.
-
Remove A/C control head with control unit.
Installing
Code Control module, Function 07, then initiate Basic setting, Function 04, with VAG 1551 Scan Tool (ST); Climatronic, On Board Diagnostic (OBD).