Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Using a Multimeter, Check the Camshaft Position (CMP) Sensor electrical harness connector terminals 1 to 3 for voltage.
Specified value: about 5.0V
-
Switch the ignition off.
If the specification was not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the Test Box 105 Pin VAG1598/31 (Engine Code ATQ ) Test Box 80 Pin VAG1598/22 (Engine Code AHA).
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) J220.
Using a Multimeter, Check the Camshaft Position (CMP) Sensor G40 or Camshaft Position (CMP) Sensor 2 G163 electrical harness connector to the
Engine Control Module (ECM) J220 electrical harness connector for an open circuit.
(Engine Code ATQ)