Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Slowly depress accelerator pedal up to Wide Open Throttle (WOT) stop while observing the percentage display.
The percentage display must increase uniformly.
-
Check specified value of throttle valve position (absolute) at Wide Open Throttle (WOT) stop:
-
End diagnosis and switch ignition off.
If specified values are not obtained:
-
Disconnect 6-pin connector -2- at the throttle valve control module -1-.
Check resistance
-
Measure resistance of Throttle drive (power accelerator actuation) -G186- in Throttle Valve Control Module -J338- between terminals 3 + 5
Specified value: 3.0 to 200.0 Ohms
If specified value is not obtained:
-
Replace Throttle Valve Control Module -J338-, Throttle valve control module, removing and installing.