Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Rapid data transfer
HELP
Select function XX
If display not indicated as shown: See Scan tool operating instructions
-
End output (function 06).
-
Switch off ignition and disconnect Data Link Connector (DLC).
NOTE:
If DTCs were recognized, follow the sequence below:
1. Rectify malfunction.
2. Erase Diagnostic Trouble Code (DTC) memory (function 05).
3. Check Diagnostic Trouble Code (DTC) memory (function 02).
Without Manufacturer Scan Tool
The manufacturer does not provide a procedure for reading diagnostic trouble codes without a scan tool.
With Manufacturer Scan Tool
Erase DTC Memory
NOTE: After DTC memory is erased, its contents are automatically output. If DTC memory cannot be erased, check DTC memory again and repair
malfunction.
Requirements
-
DTC memory checked.
-
All malfunctions repaired.
After successful DTC memory check:
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -5-. This selects "Erase DTC memory", function 05.
Indicated on display:
Rapid data transfer
Q
05 - Erase DTC Memory
-
Press -Q- button to confirm input.
Indicated on display:
Rapid data transfer
->
DTC Memory is erased!
DTC memory is erased.
-
Press -> button.
Indicated on display:
Rapid data transfer
HELP
Select function XX
NOTE:
Test sequence is faulty if this message is displayed.
WARNING !
DTC memory was not checked
Test sequence is faulty if this message is displayed.
Rapid data transfer
->