Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Continuation of test if indication is approx. 143 degrees C:
-
Disconnect connector -1- from Intake Air Temperature (IAT) Sensor -G42- (-2-).
If indication jumps to approx. -40 degrees C:
-
End diagnosis and switch ignition off.
-
Replace Intake Air Temperature (IAT) Sensor -G42-, item 10.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If indication remains at approx. 143 degrees C:
-
End diagnosis and switch ignition off.
-
Check wires according to wiring diagram.
Checking wiring
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring Test
Vehicles with engine code AHA
-
Check wires between test box and 2-pin connector for open circuit according to wiring diagram.
Terminal 1 + socket 54
Terminal 2 + socket 67
Wire resistance: max: 1.5 Ohms
Vehicles with engine code ATQ