Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Air Flow Meter/Sensor: Testing and Inspection
With Generic Scan Tool
Mass Air Flow (MAF) sensor, checking
NOTE: Use only gold-plated terminals when servicing terminals in harness connector of Mass Air Flow (MAF) sensor.
Recommended special tools and equipment
-
V.A.G 1526 multimeter or V.A.G 1715 multimeter
-
V.A.G 1594 Connector test set
-
Wiring diagram
Test requirements
-
The respective fuses of Mass Air Flow (MAF) Sensor -G70- must be OK:
-
Fuel Pump (FP) Relay -J17- must be OK, checking.
-
Battery voltage must be at least 11.5 volts.
-
All electrical consumers like, for example, lights and rear window heating must be switched off.
-
Parking brake must be engaged or else daylight driving lights will be switched on.
-
If vehicle is equipped with an A/C system, it must be switched off.
-
Ground (GND) connections between engine and chassis must be OK.
-
Coolant temperature must be at least 80 degrees C, Diagnostic mode 1: Check measuring values; PID 5, Coolant temperature. See: Testing and
Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 1: Check Measuring Values
Function test
-
Connect diagnostic tester. See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan
Tool/Diagnostic Tester, Connecting
-
Start engine and let run at idle.
-
Under address word 33, select "Diagnostic mode 1: Checking measuring values."
-
Select the measuring value "PID 16: Air flow quantity at Mass Air Flow (MAF) sensor".
-
Check specified value of air flow quantity at Mass Air Flow (MAF) Sensor at idle:
Vehicles with engine code AHA
Vehicles with engine code ATQ