Passat Syncro Wagon V6-2.8L (ATQ) (2000)
connected.
-
Use auxiliary wires from VAG 1594 to connect multimeter with terminals 3 + 4 of appropriate 4-way connector (going to control module) to make
voltage measurement.
-
Switch ignition on and measure primary voltage.
Specification: 0.40-0.50 V
-
Switch ignition off.
If expected value is not obtained on one or both Heated Oxygen Sensors (HO2S):
-
Test oxygen sensor wires.
If specified values are obtained:
-
Replace appropriate Heated Oxygen Sensor (HO2S) before catalytic converter.
Checking Oxygen Sensor Wires
-
Connect VAG 1598/31 test box to control module wiring harness. Engine Control Module (ECM) is not connected.