Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
The respective fuses of Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) -G130- and Oxygen Sensor (O2S) 2 Behind Three
Way Catalytic Converter (TWC) -G131- must be OK:
-
Battery voltage must be at least 11.5 volts.
-
All electrical consumers like, for example, lights and rear window heating must be switched off.
-
Parking brake must be engaged or else daylight driving lights will be switched on.
-
If vehicle is equipped with an A/C system, it must be switched off.
-
Ground (GND) connections between engine and chassis must be OK.
-
Exhaust system must be properly sealed between catalytic converter and cylinder head.
-
Coolant temperature must be at least 80 degrees C, Diagnostic mode 1: Check measuring values; PID 5, Coolant temperature. Refer to "Scan
Tool Testing/Diagnostic Mode 1: Check Measuring Values".
See: Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 1: Check Measuring Values
-
Oxygen sensor heater for oxygen sensors behind catalytic converter must be OK, check
Function test
-
Select the following output of oxygen sensor signals and check whether the specified values are being reached, Diagnostic mode 5: Check output
of oxygen sensor signals. Refer to "Scan Tool Testing/Diagnostic Mode 5: Check Output of Oxygen Sensor Signals"
See: Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 5: Check Output of Oxygen Sensor Signals
-
Check the specified values of the output of oxygen sensor signals at idle:
*) V = Voltage in Volts (oxygen sensor signal)
**) t = Time in seconds
Vehicles with engine code AHA