Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Remove right rear wheel well liner -1- by unscrewing seven bolts -3-
-
Remove shielding plate for fuel filler tube
-
Clean area surrounding fuel filler tube
-
Unscrew mounting bolt for fuel flap and remove fuel flap unit with rubber gasket
-
Remove securing bolts from filler neck
-
Disconnect supply line -1- from fuel filter
-
Mark return hose -2- and breather hose -3- and separate at connecting point
-
Seal lines so the fuel system is not contaminated with debris
-
Remove cover from EVAP canister
-
Disconnect ventilation lines at EVAP canister -arrows-
-
Remove tensioning straps and support fuel tank using engine/transmission jack -V.A.G 1383 A- or equivalent, if not already done
-
Lower fuel tank and proceed to Section H
Section H - Fuel Sending Unit Removal
(2001-2005 4Motion vehicles)