Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Switch ignition off.
If specified values are not obtained:
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring
Test
-
Check wires between test box and 6-pin connector for open circuit according to wiring diagram.
Terminal 1 + socket 72
Terminal 2 + socket 73
Terminal 3 + socket 36
Terminal 4 + socket 35
Terminal 5 + socket 33
Terminal 6 + socket 34
Wire resistance: max: 1.5 Ohms
-
Also check wires for short circuits to each other, to vehicle Ground (GND) and to B+.
Specified value: Infinite Ohms
If no malfunction is detected in the wiring and if the voltage supply was OK:
-
Replace accelerator pedal position sensor.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes