Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Remove brake caliper housing and secure with wire so weight of the brake caliper does not stress or damage brake hose
-
Unbolt vehicle speed sensor wiring -2-
-
Remove securing pins -1-
-
Unbolt vehicle speed sensor wiring -2- Remove securing pins -1-
-
Remove wiring from axle beam -3-
-
Disconnect ABS vehicle speed sensor from wheel bearing housing
These two steps are for vehicles with automatic headlight range control ONLY:
-
Remove nut -arrow A- and bolt -arrow B- from coupling rod -1- for vehicle level control system sensor -2-
-
Pull out coupling rod -1- in -direction of arrow-
-
Set engine/transmission jack -V.A.G 1383A- equivalent under rear final drive
-
Remove axle beam bolts
-
Lower sub frame using engine/transmission jack -V.A.G 1383A- or equivalent