Passat Syncro Wagon V6-2.8L (ATQ) (2000)
(Engine Code AHA)
Specified value: 1.5 ohms Max.
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring and voltage supply was OK:
-
Replace the Camshaft Position (CMP) Sensor G40 or Camshaft Position (CMP) Sensor 2 G163 .
If no malfunction is found in the wiring and voltage supply was not OK:
-
Erase the DTC memory.
-
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code.
-
End diagnosis.
If the DTC does return and no malfunction is detected in the wiring and the voltage supply was OK:
-
Replace the Engine Control Module (ECM) J220.
-
Assembly is performed in the reverse of the removal.
Final procedures
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory.