Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Connect VAG 1598/31 test box to control module wiring harness. Engine Control Module (ECM) is not connected.
-
To measure voltage, connect multimeter between sockets 3 (terminal 15) + 54 (speed signal) of test box.
-
Switch ignition on.
-
Jack up front left wheel.
-
Rotate front wheel, and observe voltage indicated while doing so.
Specification: between 0 and at least 4 volts, oscillating
If indicated voltage does not oscillate:
-
Check wires going to speedometer and speed sensor.