Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Carefully pull button -2- out of selector lever handle -3- until dimension -a- is obtained.
Dimension -a- = 5 mm
-
With button -2- facing front of vehicle, install handle -3- onto selector lever and push down onto stop.
-
Turn handle -3- until button -2- faces driver's side. Handle will then engage in vertical groove in selector lever-8-.
-
Push handle -3- down fully so that it engages in circular groove in selector lever -8-.
-
Press button -2- into selector lever handle -3-.
The pull lever -4- will then locate in pull rod -5- and will pull the pull rod up as it moves along the inclined portion (arrow).
-
Pull up sleeve -1- until it engages in selector lever handle -3-.
Removing And Installing Securing Spring For Locking Cable
Removing
-
To remove locking cable, lift spring slightly at top (arrow -B-).
-
Disengage spring (arrow -A-) from retainer lug (arrow -C-) and lift out.
Installing
-
Install spring from above (arrow -B-) and engage under retainer lug (arrow -C-).
-
Align spring so that it lies level in groove (arrow -A-).
-
To install locking cable, lift spring slightly at top (arrow -B-).