Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Do not kink selector lever cable
-
Install selector lever cable in mounting bracket.
-
Install mounting bracket on body.
Tighten nuts (Qty. 4) from above to 10 Nm (7 ft. lbs.).
-
Connect harness connectors.
-
Install locking cable and adjust.
-
Install cover.
-
Shift selector lever into position "2."
-
Install selector lever handle.
-
Connect selector lever cable to selector lever.
-
Install locking plate -A- for selector lever cable onto mounting bracket.
-
Installation position: the angled end of the locking plate must point toward the end of the selector lever cable
-
Press together ends of securing clip -B- and slide onto end of selector lever cable.
-
Install cover. When doing this check position of seal.
-
Tighten nuts (Qty. 4) to 10 Nm (7 ft. lbs.).
-
Check selector lever cable adjustment, adjust if necessary.
-
Check operation of ignition key withdrawal lock.
-
Install drive shaft.
-
Install front left and right-hand exhaust pipes.
-
Install center console and extension.
-
Reconnect battery Ground (GND) strap.
-
Input correct coding for anti-theft radio (if equipped).
-
Check selector mechanism.
Disassembling and Assembling
SELECTOR LEVER MECHANISM, DISASSEMBLING AND ASSEMBLING (WORK SEQUENCE)
Special tools and equipment
^
VW421 Tube, 28 mm Dia., 100mm