Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Seals and Gaskets: Service and Repair
Rear final drive installed
-
Observe general repair instructions. See: Service and Repair/General Repair Instructions
Special tools and equipment
^
VW391 Puller
^
VW771 Slide hammer-complete set
^
VW771/37 Puller hooks
^
3026 Mandrel
^
3028 Retainer
^
3143 Seal driver
Removing
-
Only if there are no marks, mark position of rear drive shaft sections on constant velocity joints with paint (arrows -A- and -B-).
-
Disconnect drive shaft from rear final drive and tie up.
-
Place VAG1383 A engine/transmission jack with 1359/2 universal transmission mount under rear final drive to support