Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Slide a hammer handle between window channel and SF so far until hammer handle end presses on gears of SF.
-
Remove cable tie - 1 -.
-
By removing window regulator motor, gearing shifts, it is not centered.
-
When installing window regulator motor, gears must be aligned until window regulator motor is centered again.
-
Attach and tighten bolts - 1 -, tightening torque: 3.5 Nm.
Tightening torque must always be observed since otherwise damage to plastic sleeve on window regulator motor can result.