Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
-
Remove fan retainer and belt pulley toothed belt protection.
-
Take off toothed belt.
Installing
-
Remove securing bolts for camshaft sprocket and take off securing plate.
-
Fit an M10 bolt into hole as a counter hold for puller 3032.
-
Release camshaft sprocket with puller 3032. Then using securing bolts and securing plates tighten hand tight again.
Note: It must be possible to just turn the camshaft pulleys on the camshaft tapers.
-
Route toothed belts as shown. Observe direction of rotation for used toothed belts.