Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
Continuation for all vehicles
-
Also check wires for short circuit to B+ or Ground (GND).
Specified value: Infinity Ohms
-
Check wire between 4-pin connector terminal 1 and Fuel Pump (FP) Relay -J17- for open circuit according to wiring diagram.
Wire resistance: max: 1.5 Ohms
If no malfunctions are found in wires:
-
Replace Motronic Engine Control Module (ECM) -J220-.
With Manufacturer's Scan Tool
Oxygen Sensor (O2S) heater behind TWC, checking
Special tools and equipment
-
VAG1551 or VAG1552 Scan Tool (ST) with VAG1551/3 adapter cable
-
VAG1598/22 test box
-
Multimeter US1119 (Fluke 83 or equivalent)
-
VW1594 connector test kit
-
Wiring diagram
Checking requirements
-
Fuse 29 OK
-
Battery voltage: min. 11.5 volts
-
Fuel pump relay OK
-
Engine coolant temperature at least 85 °C (185 °F) See VAG1551 scan tool function 08, display group 004, display field 3
Checking
-
Connect VAG1551 or VAG1552 scan tool and press buttons -0- and -1- to insert "Engine Electronics" address word 01 (with engine running at
idle), Refer to "Scan Tool Testing/Scan Tool Connecting and Initial Checks/Connecting VAG1551/VAG1552 Scan Tool" under "Engine", See:
Testing and Inspection
Indicated on display
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -8- to select "Read Measuring Value Block" function 08, and press -Q- button to confirm input.