Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
/Page-1346001.png)
Throttle Cable/Linkage: Adjustments
Throttle cable, adjusting
Vehicles with manual transmission
-
Adjust accelerator pedal cable by moving retainer (arrow) at support bracket, so full throttle position is attained at throttle valve control
module.
Vehicles with automatic transmission
Special tools and equipment
^
Multimeter Fluke (R) 83
^
VW 1594 connector test kit
-
Adjust accelerator pedal cable by moving retainer (arrow) at support bracket, so full throttle position is attained at throttle valve control
module.
-
Release accelerator pedal.
-
Disconnect 2-pin harness connector of kickdown switch -F8- in engine compartment (on the bulkhead).
-
Connect multimeter Fluke (R)83 with aux. cables from VAG 1594 to kickdown switch.
-
Check resistance at kickdown switch.
Specification: - Ohms
-
Slowly move accelerator pedal in direction of full throttle.
Shortly after the kickdown pressure point the resistance must drop to: 0 Ohms.
At this point the accelerator pedal must be just off the stop.
