Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
Continuation for all vehicles
-
End diagnosis and switch ignition off.
If specified value is obtained, but DTC memory has a DTC concerning Mass Air Flow (MAF) sensor:
-
Check voltage supply of Mass Air Flow (MAF) sensor.
If specified value is not obtained:
-
Check signal and Ground (GND) wires of Mass Air Flow (MAF) sensor.
Voltage supply for Mass Air Flow (MAF) sensor, checking
Vehicles with engine code AHA
-
Disconnect 3-pin connector from Mass Air Flow (MAF) Sensor -G70-.
-
Connect multimeter to terminal 3 of connector and engine Ground (GND) for voltage measurement.
-
Switch ignition on.
Specified value: at least 11.5 V
-
Switch ignition off.
If there is no voltage:
-
Check wire between 3-pin connector terminal 3 and relay carrier for open circuit according to wiring diagram.
Wire resistance: max: 1.5 Ohms
Vehicles with engine code ATQ
-
Disconnect 4-pin connector from Mass Air Flow (MAF) Sensor -G70-.
-
Connect multimeter to terminal 3 of connector and engine Ground (GND) for voltage measurement.
-
Start engine, and let run at idle.