Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
Wiper Motor: Service and Repair
Removing and Installing Wiper Motor From Frame
Removing Wiper Motor From Frame
-
Pry linkages -1- from wiper motor crank using a large screwdriver.
-
Remove M8 hex nut -2-.
-
Remove wiper motor crank.
-
Remove all M6 mounting bolts -3-.
Installing wiper motor in frame
NOTE: Ensure that wiper motor is in park position. If necessary, connect the electrical connector and operate wiper switch briefly. Electrical connector
must be disconnected again prior to installation.
-
Install all M6 hex bolts to secure motor.
Tightening torque: 8 Nm (71 in lb)