Passat Wagon L4-1781cc 1.8L DOHC Turbo (ATW) (2000)
Note
A straight edge against tabs on fuel level sending unit will assist in arrow alignment.
^
Reinstall nut and tighten to 30 Nm (22 ft. lbs.) using tool 2012A.
^
Reconnect harness connector to fuel level sending unit cover.
^
Proceed to Section F
Section F - Checking and Reassembly
^
Reconnect the ground cable (GND) to the negative (-) battery terminal and torque bolt to 5 Nm (44 in. lbs.)
^
Turn ignition to ON position.
^
Check fuel gauge reading, it should indicate empty.
^
Turn ignition to OFF position.
^
Fill fuel tank by using removed fuel first, then add additional fuel, as required.
^
Connect VAS 5051.
^
Turn ignition to ON position.
^
Check and clear any faults in memory of control units and disconnect VAS 5051 from vehicle.
^
Check fuel gauge reading, it should indicate full.
^
Start engine and check for leaks.
^
Set readiness code.
^
Using switches, fully close power windows up to stop.
^
Operate all power windows for at least 1 second in "close" position to activate "one touch" opening/closing feature.
^
Where necessary, set Climatronic and power seat adaptation.
^
Reset clock and all radio preset stations.
^
Switch ignition to OFF position.
^
Reinstall covers (on floor pan) on right and left side (under rear seat bottom).
^
Reinstall or reposition rear seat bottom.
^
Reinstall cover (on floor pan) in luggage compartment.
^
Reinstall carpeting in luggage compartment area.