Passat Wagon L4-1781cc 1.8L Turbo (AEB) (1998)
Ribbed Belt: Procedures
Coolant Pump V-Belt
Engine coolant pump V-belt, removing and installing
Special tools, testers, measuring instruments and auxiliary items required
-
Punch
-
VAG 1331 Torque wrench: 5 to 50 Nm (3.7 to 37 ft lbs)
Removing
-
Remove viscous fan coupling (with belt pulley). See: Cooling System/Radiator Cooling Fan/Fan Clutch/Service and Repair
-
Mark installed position of 2-piece coolant pump belt pulley
-
Secure power steering pump belt pulley using a drift.
-
Unscrew coolant pump 2 piece coolant pump belt pulley and remove V-belt.
Installing
-
Install 2-part belt pulley on coolant pump and fit V-belt between coolant pump and power steering pump.
-
Tighten belt pulley evenly until V-belt has moved outward to its running surface. If necessary, turn power steering pump belt pulley or coolant
pump slightly.
-
Secure power steering pump belt pulley with drift.
-
Tighten coolant pump belt pulley
-25 Nm (18 ft. lbs.)
Note:
It is not necessary to adjust V-belt tension.
-
Install viscous fan coupling.
Ribbed Belt Routing
Ribbed Belt, Routing