Passat Wagon L4-1781cc 1.8L Turbo (AEB) (1998)
If specification obtained
-
Press -> button.
-
Press 0 and 6 buttons to select Function 06: "End data transfer"
-
Press Q button to enter input
-
Switch OFF ignition.
Significance of figures in 4 digit number block in Display zone 4, Display group 56
NOTE: If DTC memory has been erased or the Engine Control Module was disconnected from its Voltage supply, the Readiness Code must be created
again , Refer to "Computers and Controls", See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes
Continuation
If display does not change:
-
Connect VAG 1598/22 Test Box to Engine Control Module harness connector.