Passat Wagon L4-1781cc 1.8L Turbo (AEB) (1998)
Preparing undamaged window for glazing.
Preparing new window for glazing.
Preparing window flange for glazing.
Installation notes.
Minimum curing time.
Installation Notes
Installation Notes
-
Apply adhesive material all around onto pre-coating - 1 - at right angle to window.
CAUTION: Window must be installed within 10 minutes, otherwise bonding properties of window adhesive will be impaired.
-
Insert window into window cut out using two Double suction lifters V.A.G 1344, center and press in up to spacer.
-
Gap dimension of windshield.
-
Rear window gap dimension.
-
Gap dimension of rear window, wagon, 4.5 mm all around.
-
Secure windshield using Window adjuster 443 845 631 A during curing time.
-
Plenum chamber cover must always be installed as described on page.
-
Re-affix any stickers (e.g. for airbag).
-
When installing mirror - 1 -, attach at 6090° offset to installation position and turn - arrow - until retaining spring engages.
-
Install interior mirror.
-
Install interior mirror with rain sensor.
-
Secure rear window using adhesive tape during curing time.
-
If adhesive bead has been applied too thick and adhesive expands onto area of window heating,then excess adhesive must be removed.
-
First install side window of wagon using securing pins.
-
When re-using removed window.