Passat Wagon L4-2.0L Turbo (BPY) (2008)
-
Insert special tools with bonded rubber bushing into subframe as illustrated.
1- Nut T10263/5
2- Guide Piece T10356/3 with side A toward subframe
3- Subframe
4- Bonded rubber bushing
5- Thrust Piece T10356/4 with side A toward bonded rubber bushing
6- Tube T10356/2
7- Hydraulic Press VAS 6178 with Pressure Head T10205/13
8- Nut T10263/5
9- Spindle T10263/4
-
Pretension special tool with bonded rubber bushing.
-
Carefully insert bonded rubber bushing by operating pump until collar lies on subframe "without a gap".
Pulling out rear bonded rubber bushing
-
Install special tools as depicted in the illustration.
1- Nut T10263/5
2- Press piece T10356/5
3- Subframe
4- Tube T10356/6
5- Hydraulic Press VAS 6178 with Pressure Head T10205/13
6- Nut T10263/5
7- Spindle T10263/4
-
Pretension special tools.
-
Pull out bonded rubber bushing by operating pump.
Note:
^
The bearing outer race is sheared off when the bonded rubber bushing is removed. There is a loud crack when this happens.
^
After removing the bonded rubber bushing, it must be removed from the Tube T10356/2 by tapping lightly with a hammer.
Pulling in rear bonded rubber bushing