Passat Wagon L4-2.0L Turbo (BPY) (2008)
Sound Proofing / Insulation: Service and Repair
Noise Insulation Panel Assembly Overview
Long Version
Noise Insulation Assembly Overview, Long Version
Slight changes may have to be made to removal and installation procedures, depending upon engine installed in vehicle.
The screws -3- are micro-encapsulated and must be replaced after loosening.
1
Noise Insulation
Arrow - points in direction of travel.
Removing:
Remove the screws -2- and -3-.
Pull the noise insulation toward the rear out of the lock carrier mounts.
2
Bolt
Quantity: 9
Tightening specification: 2 Nm
3
Bolt
The screws are micro-encapsulated.
Always replace bolts after loosening.
Quantity: 3
Tightening specification: 6 Nm
Short Version
Noise Insulation Assembly Overview, Short Version
Slight changes may have to be made to removal and installation procedures, depending upon engine installed in vehicle.