Passat Wagon L4-2.0L Turbo (BPY) (2008)
-
Disengage the securing clip - 2 - using a screwdriver or a pointed tool and pull it out of the master cylinder until it stops.
-
Disconnect the hose/line assembly or plastic line - 1 - from the master cylinder and seal it.
-
Unclip the clutch position sensor (G476) from the master cylinder - arrow - and remove it.
-
Disconnect the electrical connector - 4 -.
Installing
Installation is performed in the reverse order of removal. Pay attention to the following:
If the hose/line assembly or plastic line was removed:
-
Install the hose/line assembly or plastic line - 1 - with a new seal - 2 - to the master cylinder connection - 4 - until the securing clip - 3 - engages
audibly.