Passat Wagon L4-2.0L Turbo (BPY) (2008)
-
Install the oil pump chain sprocket and tighten the bolt by hand.
‹› The oil pump chain sprocket fits only in one position. To install, only the oil pump must be turned.
-
Remove the (T10027) and the hex wrench - 1 -. Tighten the oil pump chain sprocket bolt. Tightening specification: 20 Nm + an additional 90°
(1/4) turn. Counter hold at the vibration damper center bolt.
-
Install the oil pan. Refer to => [ Oil Pan ] See: Engine Lubrication/Oil Pan/Service and Repair/Oil Pan.
The rest of the installation is basically a reverse of the removal sequence.
Balance Shaft Drive Bolt Allocation