Passat Wagon L4-2.0L Turbo (BPY) (2008)
-
Remove securing latch - 3 - from harness connector - 2 -.
-
Disengage lock - arrow B - on electrical connection - 2 - and disconnect from steering column electronic systems control module.
Installing:
Install in reverse order of removal, noting the following:
‹› Make sure that none of the pins are bent and that the connector clicks into the place.
Airbag Spiral Spring/Return Spring With Slip Ring (F138), Through 10.09
Steering Column Switch
Airbag Spiral Spring/Return Spring With Slip Ring (F138), Through 10.09
Removing:
-
Disconnect battery. Refer to => [ Battery, Disconnecting and Connecting ] See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery, Disconnecting and Connecting.
Remove the following components in order:
-
Remove steering wheel.
-
Remove steering column trim.
-
Remove Steering Column Electronic Systems Control Module (J527). Refer to => [ Steering Column Electronic Systems Control Module,
Through 10.09 ]. See: Steering Column Electronic Systems Control Module (J527), Through 10.09
‹› When removing, the spiral spring must not be twisted out of the center position and wheels must be in the straight ahead position.
-
Lift both retaining straps - arrows - on Airbag Spiral Spring/Return Spring With Slip Ring - 1 - slightly and pull off Airbag Spiral Spring/Return
Spring With Slip Ring toward rear from steering column.