Passat Wagon L4-2.0L Turbo (BPY) (2008)
-
Open the shut-off valve of the High pressure fuel gauge.
-
Start the engine and let it run at idle.
CAUTION!
Shut-off valve must only be closed slowly. At a fuel pressure of 8 bar, shut-off valve must be opened again immediately to prevent damage
to pressure measuring device.
-
Slowly close the shut-off valve of the High pressure fuel gauge. Pressure must increase to min. 6.0 bar. If 6 bar is reached, open shut-off valve
again immediately!
If the fuel pressure increases:
-
The pressure relief valve in the fuel filter malfunctioning, replace the fuel filter.
If the fuel pressure does not increase:
-
Replace the fuel pump.
-
Assembly is performed in the reverse of the removal.
Final Procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Powertrain Management/Computers and