Passat Wagon L4-2.0L Turbo (BPY) (2008)
‹› M6 x 16
‹› 8 Nm
5
Tie Rod End
6
Wheel Hub with Wheel Bearing
‹› Sensor ring for ABS is installed in wheel hub.
‹› Various versions.
7
Nut
‹› M12 x 1.5
‹› Pre-tighten to 100 Nm, then loosen by 180° and tighten to 100 Nm again.
‹› Self-locking
‹› Always replace after removal.
8
Internally Vented Brake Disc
9
Bolt
‹› M16 x 1.5 x 80
‹› Hex head bolt: 200 Nm + 180° turn.
‹› Twelve-point bolt: 70 Nm + 90° turn.
‹› Always replace after removal.
CAUTION!
Vehicle must not be standing on its wheels when loosening or tightening.
10
Bolt
11
Bolt
‹› M6 x 12
‹› 12 Nm
12
Cover Plate
13
Wheel Bearing Housing
‹› Removing and installing, refer to => [ Wheel Bearing Housing ] See: Front Suspension/Wheel Bearing Housing.
‹› With bolted brake carrier.
‹› If a wheel bearing housing is replaced, vehicle must then be aligned. Refer to => [ Wheel Alignment Overview ] See: Alignment/Service and
Repair/Wheel Alignment Overview.
14
Bolt
‹› M12 x 1.5 x 45
‹› 70 Nm + 90° turn
‹› Always replace after removal.
15
Drive Axle