Passat Wagon L4-2.0L Turbo (BPY) (2008)
‹› If the Engine Control Module (ECM) will be replaced, connect the vehicle diagnostic tester and perform the "Replacing Engine Control Module"
guided function.
DANGER!
On vehicles with a heavy duty suspension, vehicle must be limited to a maximum speed of 210 km/h with the ECM. At speeds above 210
km/h, damage to input shafts can occur. Perform guided function " Limit Maximum Speed" using the vehicle diagnostic tester.
Special tools, testers and auxiliary items required
‹› Locking Pliers
-
If it is desired to replace the ECM, connect the vehicle diagnostic tester and perform the guided function "Replace Engine Control Module
(ECM)".
Removing
-
Turn the ignition off.
-
Remove the windshield wiper arms.
-
Remove the plenum chamber cover.
‹› Covers are installed in some vehicles to protect the ECM from damage. They are secured to the ECM with bolts - 1 -.
-
Remove the bolts - 1 -.
-
Remove the cover, if present.
-
Cover the plenum chamber with a clean cloth so that it does not get scratched.
-
Raise the ECM slightly together with the bracket.
-
Release the ECM - arrows - and pull it out slightly.
-
Bend the raised ends - 1 - of the locking bracket outward.