Passat Wagon L4-2.0L Turbo (BPY) (2008)
Specified value: min. 4.5 V
-
Switch the ignition off.
If the specification was not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to => [ Motronic Engine Control Module J623, Replacing ] See: Computers
and Control Systems/Engine Control Module/Service and Repair/Motronic Engine Control Module J623, Replacing.
-
Using a multimeter, check the Charge Air Pressure Sensor (G31) electrical harness connector terminals to the Motronic Engine Control Module
(ECM) (J623) electrical harness connector T94 terminals for an open circuit.
Specified value: 1.5 ohms max.