Passat Wagon L4-2.0L Turbo (BPY) (2008)
Electronic Throttle Control Module: Removal and Replacement
Throttle Valve Control Module
Removing
-
Remove engine cover/air filter.
GTI
-
Remove pipe - A - and hose - B - - arrows -.
Continuation for All
-
Loosen the hose clamp - 1 -.
-
Remove bolt - 2 -.
-
Remove noise insulation.
-
Disconnect electrical connector - 3 -.
-
Remove the bolt - 4 -, pull the guide pipe off the charge air cooler and remove it downward.
-
Remove four bolts on throttle valve control module J338 and remove it.
Installing
Installation is performed in the reverse order of removal, noting the following:
-
If a new throttle valve control module J338 was installed, adapt the engine control module to the throttle valve control module J338 "Guided
Functions".