Passat Wagon L4-2.0L Turbo (BPY) (2008)
‹› Without rear side airbags, refer to => [ Side Upholstery without Side Airbag ] See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Rear Seats
-
Remove luggage compartment side trim (wagon):
‹› Right, refer to => [ Right Luggage Compartment Side Trim ] See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/Luggage Compartment Trim
‹› Left, refer to => [ Left Luggage Compartment Side Trim ] See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage
Compartment Trim
-
Remove D-pillar trim panels. Refer to => [ D-Pillar Trim ] See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim.
Vehicles in which an interior rearview mirror with rain sensor is installed:
-
Remove the side cover caps from the interior rearview mirror. Refer to => [ Interior Rearview Mirror with Rain Sensor ] See: Body and
Frame/Mirrors/Service and Repair/Interior Rearview Mirror
All vehicles:
-
Remove headliner, wagon, refer to => [ Molded Headliner ] See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair
CAUTION!
Electrostatic discharges can lead to an unintended deployment of the airbag. Therefore the technician must discharge static electricity
from the body before separating the ignition and ground wiring. This is done, for example, by briefly touching the body or the door
striker or pin.
-
Disconnect wiring harness from side curtain airbag
-
Remove bolts - 1 - and - 2 - (4.5 Nm).
-
Remove five screws - arrows - (4.5 Nm).
-
Remove the two bolts - 3 - (4.5 Nm).
-
Remove side curtain airbag from mounts in body.