Passat Wagon L4-2.0L Turbo (BPY) (2008)
Contact is ejected from the terminal housing.
-
After ejecting the contact, release tool can be pulled out of terminal housing again.
Contacts without retaining tabs:
-
Insert release tool under retaining tab of terminal housing.
-
Push release tool through until it stops by gently lifting - arrow -.
Contact is ejected from the terminal housing.
Table of Contents
Removal and Installation
=> [ 4-Pin Heated Oxygen Sensor ] See: Powertrain Management/Computers and Control Systems/Oxygen Sensor/Service and Repair/Removal and
Replacement/4-Pin Heated Oxygen Sensor
=> [ 6-Pin Universal Oxygen Sensor ] See: Powertrain Management/Computers and Control Systems/Oxygen Sensor/Service and Repair/Removal
and Replacement/6-Pin Universal Oxygen Sensor