Passat Wagon L4-2.0L Turbo (BPY) (2008)
Steering Column Control Module: Service and Repair
Steering Column Switch
Steering Column Switch
Steering Column Electronic Systems Control Module (J527), Through 10.09
‹› After installing a new control module, it must be coded. Refer to => [ Steering Column Electronic Systems Control Module, Coding, Through
10.09 ] See: Testing and Inspection/Programming and Relearning/Steering Column Electronic Systems Control Module (J527), Coding, Through
10.09.
‹› If malfunctions occur at steering column switch, coding of control module must be checked. Refer to => [ Steering Column Electronic Systems
Control Module, Coding, Through 10.09 ] See: Testing and Inspection/Programming and Relearning/Steering Column Electronic Systems Control
Module (J527), Coding, Through 10.09.
Removing:
-
Disconnect battery. Refer to => [ Battery, Disconnecting and Connecting ] See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery, Disconnecting and Connecting.
-
Remove steering wheel.
-
Remove steering column trim.
-
Remove the bolt - 2 - on Steering Column Electronic Systems Control Module - 1 -.
-
Disengage connector - 1 - on right side of control module by pressing on the latching button - 2 - in direction of arrow and disconnect connector -
1 - from steering column electronic systems control module - 3 -.