Passat Wagon L4-2.0L Turbo (BPY) (2008)
Central CM deactivating factory mode -J393-.
-
Perform the function test
Once the function is complete the Comfort System Central Control Module -J393- will be out of factory mode.
Comfort Control Module -J393- Coding
-
Select Chassis -> Body Collision Repair -> Convenience system -> Functions - Central CM for convenience system -> Replacing/coding Comfort
System Central Control Module -J393-.
-
Select "Yes" when questioned if you want to replace or code control module.
-
Select option "1" to use online coding or option "2" if you were able to retrieve your coding before parts replacement.
-
If you were unable to retrieve the long coding, attempt to perform the on-line coding. If the on-line coding fails, contact technician helpline to
obtain long coding and then select option "2".
TIP: Once coding is performed, a screen may appear stating that the coding was not accepted, but the screen will display the coding that you
entered manually using option ".2", continue with bulletin.
-
Select "Done" to accept coding.
Radio-Remote Control (Key) - Adapting
-
Select Chassis -> Body Collision Repair -> Convenience system -> Functions Central CM for convenience system -> Adapting Keys with
Radio-remote Control -J393-.
-
Perform the function test to adapt the remotes
NOTE: ALL KEYS MUST be present to perform procedure. If all keys are not present, procedure will have to be performed again.
ABS Control Module - Coding
-
Select "Operating Mode -> Guided Fault Findings".
-
Select "Go To -> Functions/Components Selection -> Suspension -> Brake System -> 01 - Onboard Diagnostic (OBD) Capable System TRW 440
ABS System ABS/EDL/ASR with ESP -> Functions -> Coding ABS Control Module (w/EDL) -J104-".
NOTE: DO NOT continue when prompted to set basic settings for -G85-.
ABS Adaptation
-
Select "Go To -> Functions/Components Selection -> Suspension -> Brake System -> 01 - Onboard Diagnostic (OBD) Capable System TRW 440
System ABS/EDL/ASR with ESP -> Functions -> Basic Settings Longitudinal Acceleration Sensor -G251-".
-
Perform Basic settings for the -G251-.
-
Repeat procedure for -G200-, -G201-, and -G202-.
Parking Brake - Basic Settings
NOTE: Parking brake must be OFF. You must hold down the brake pedal and then push button momentarily in order to disengage the parking brake.