Passat Wagon L4-2.0L Turbo (BPY) (2008)
Rear Subframe Mount: Service and Repair
Front Wheel Drive (FWD)
Subframe Bonded Rubber Bushings
Special tools, testers and auxiliary items required
‹› Tensioning strap (T10038)
‹› Locating pins (T10096)
‹› Engine/transmission jack (V.A.G 1383 A)
‹› Hydraulic Press (VAS 6178) with Pressure Head (T10205/13)
‹› Hollow piston cylinder (VAS 6179)
‹› Assembly tool (T10356)
-
Remove rear wheels.
-
Remove coil springs. Refer to => [ Coil Spring ]. See: Service and Repair/Removal and Replacement/Rear Suspension/Front Wheel Drive
(FWD)/Removal and Installation/Coil Spring
-
Disconnect electrical connections between subframe and body.
-
Remove the stabilizer bar. Refer to => [ Stabilizer Bar ]. See: Service and Repair/Removal and Replacement/Rear Suspension/Front Wheel Drive
(FWD)/Removal and Installation/Stabilizer Bar
-
Now secure vehicle on both sides to lifting arms on hoist with (T10038).
CAUTION!
If vehicle is not secured, it could slide off of hoist.
-
Place (V.A.G 1383 A) with (V.A.G 1359/2) below subframe and secure with strap.