Passat Wagon L4-2.0L Turbo (BPY) (2008)
Headlamp Washer Reservoir: Service and Repair
Windshield and Headlamp Washer Fluid Reservoir Lower Section
Windshield and Headlamp Washer Fluid Reservoir Lower Section
Special tools, testers and auxiliary items required
‹› Torque Wrench (V.A.G 1783)
‹› The following illustration shows the Sedan version of the washer fluid reservoir with the Windshield Washer Pump (V5) installed. The Windshield
And Rear Window Washer Pump (V59) and two hose connections are installed here on the Wagon model.
‹› In order to prevent interchanging washer fluid line connections at Windshield and Rear Window Washer Pump, connections at pump and hose
lines are color-coded. Hose connector pieces must be connected to the corresponding colored pump connections during installation.
Removing:
-
Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).
-
Remove the windshield and headlamp washer fluid reservoir upper section. Refer to => [ Windshield and Headlamp Washer Fluid Reservoir
Upper Section ] See: Windshield Washer Reservoir/Service and Repair/Windshield and Headlamp Washer Fluid Reservoir Upper Section.
-
Unclip all lines from the reservoir upper section - 8 -.
-
Disconnect the connector - 1 - on the Headlamp Washer Pump (V11) - 2 -.
-
Disengage and disconnect harness connector - 5 - of Windshield Washer Pump - 3 -.
-
Disconnect the Windshield Washer Fluid Level Sensor (G33) - 6 - connector - 7 -.
-
Disconnect hose connection - 4 - from Windshield Washer Pump - 3 - and use a suitable container to collect the draining washer fluid.
-
Remove the screw - 1 - on the windshield and headlamp washer fluid reservoir lower section - 2 -.